ADVANTAGES

• Electrostatic conductivity
• Easy to apply
• Forms a hard film
• The film surface is glossy and slippery, preventing water and oil permeability
• Easy to clean
• Does not harbor bacteria
• Does not produce dust

SURFACE PREPARATION

• Surfaces to be applied must be free from oil, dust, and dirt. Loose particles on the surface, cement slurry on concrete surfaces, and materials that prevent adhesion must be removed.

MIXING

• Components A and B should be mixed using a low-speed mixer for at least 3-4 minutes until a homogeneous mixture is achieved, following the correct mixing ratios. The mixture is ready for application after mixing.

COATING SYSTEM

• After the curing of ELAPUR ANTI – AST conductive primer (12 hours at 25°C), grounding strips are placed. The strips are connected to the main line of the structure. After completing the SC 470 antistatic epoxy coating mixture, apply it to the surface with a roller or notched trowel.

APPLICATION CONDITIONS

• Surfaces must have adequate strength. Concrete should have a minimum compressive strength of 25 N/mm² and at least 1.5-2 N/mm² tensile strength.
• Surfaces should be clean, smooth, dry, and have a moisture content not exceeding 5%. If the moisture content exceeds this, IYS 003 Epoxy Primer for 100% Moisture Surfaces should be used on damp surfaces.
• The conductive system’s final coat should be applied only after the ELAPUR ANTI – AST Epoxy Conductive Primer has fully cured.
• Application should be avoided in environments below 10°C or in very humid conditions.
• Proper mixing ratios should be followed.

RECOMMENDED PRODUCTS FOR USE UNDER THIS PRODUCT

• ELAPUR ANTI – AST Epoxy Conductive Primer

INTERCOAT DRYING TIME

• Between coats, allow 12-24 hours at 20°C.
• For subsequent coats, the minimum waiting time is 24 hours, and the maximum is 48 hours.

PACKAGING

• 25 kg set
  • Component A: 20 kg tin
  • Component B: 5 kg tin

STORAGE CONDITIONS

• Store in a dry environment, protected from freezing, between +5°C and +30°C, in its original packaging.
• Do not stack more than three pallets; avoid stacking pallets for long-term storage.
• If stored under appropriate conditions, the product can be kept for up to 12 months from the production date.

TECHNICAL DATA SHEET